Visa detaljer
Vägledande monteringstid: 0,15Tim
Vikt: 0,50 KG
Storlek (LxHxB): 15x8x3 cm
Antal per bil: Okänt antal
Set includes
- Drill with handle
- Awl with handdle
- 5 rubber cords, each 10 cm long
- Tube of glue (12g)
How to use the kit:
1. Locate the area where the tyre has been punctured.
2. Grease the cutter with the glue provided and drive it into the hole, following the angle of the hole fill it well with glue.
3. Thread the cord onto the awl and bend it in half with the ends up.
4. Apply glue to the cord and use the awl to press it into the hole, following the angle of the previous penetration. With a firm motion, push the awl and cord through the damaged area.
Make sure that the cord goes all the way through the tyre.
Be careful not to pull the entire cord inwards.
The two ends of the cord should protrude approximately 0.5 - 1cm above the tyre tread. Firmly remove the stalk from the tyre (do not twist the stalk inside the tyre when removing it - this may break it).
5. Cut off the two protruding ends of the cord leaving 5mm above the tyre. The cord will flush with the tread surface as you drive.
Låt vår BMW-specialiserade verkstad göra jobbet! Kontakta oss för prisförslag på mail: verkstad@schmiedmann.se eller tel: 0300 - 308 08!
Allt för BMW och MINI! Notera! Vi har “bara” ca 27.000 nya och begagnade produkter i vår onlinekatalog av över 500.000 BMW & MINI-produkter tillgängliga, så tveka inte på att kontakta vår kundtjänst om det är något du inte hittar på hemsidan! Kom ihåg att vi har det största utbudet av BMW & MINI-produkter så kontakta gärna oss gärna för assistans med att hitta rätt produkter för din BMW: info@schmiedmann.se